Motorcycle Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
182 Posts
Discussion Starter · #1 ·
Im in the middle of replacing the seals in the shocks. whats got me held up is how do you dig the old seals out ? my service manual says just to use a old dull screw driver easyer said then done i dont want to pry too hard so i dont break them. they are cast aluminum after all. so who evers got advice im all ears.
 

·
Registered
Joined
·
182 Posts
Discussion Starter · #2 ·
got them out with the assistance of a bottle torch, i used propane gas stead of mapp gas. the other way i heard to do it was to use a old turkey fryer full of old motor oil and submerge them and the seals will float out. dont forget to get a set of tongs to get the shocks back out.
 
1 - 2 of 2 Posts
Top