[matthew.malinovsky89]

first was hearing a sizzling noise near starter solenoid. replaced it, now cant get a turnover. I may have to replace wiring harness. As to test its continuity, I have to remove the harness, but don't want to unless absolutely necessary. I got a new battery, checked fuses, still cannot start up. Any suggestions?

 

[matthew.malinovsky89]

I was outside in TX, where it is always windy, no way to smell it, just hearing the sizzle. but, it would still turnover, until finally gave out with a sizzle and popping sound.
I did replace the starter solenoid which is where the sound was located, but still won't start.

 

[matthew.malinovsky89]

no power, so have to do continuity only. I would have to disconnect the whole harness to test it. or make multiple cuts into every wire.