[Kmcoon]

Messing with in-laws TS90 carburetor and pulled the line that runs up into the motor. There’s the main fuel line, the line that is bolted down, and the secondary line. Question is, what’s the best way to get in there and hook it back up? Can’t see or feel anything in there. Can’t figure I have to disassemble everything to get to it. Thanks!

 

[Porky]

Welcome to the fun of motorcycle repair and maintenance!
Remove the gas tank and all will be revealed. While you are there, replace the old rubber fuel lines.

Welcome to the forum!
Sam

 

[Kmcoon]

Thank you so much, I can’t find any diagrams anywhere, and I couldn’t believe I would have to pull the whole trans cover off to hook up a stupid fuel line. I’ll check it out in the morning!

 

[Porky]

It isn't a trans cover, it's the carb and rotary valve cover and it's very easy to take off. I have attached a picture so you can see what I see: The right side cover where the throttle and choke cable and fuel line go through.

Sam

 

[Kmcoon]

Here is a pic, the brown line goes somewhere, how do I get there?

 

[Porky]

Pull the carb off and you may be able to see where the oil injection line terminates.
sAM