Motorcycle Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
i have a 1999 Gsxr SRAD 750. i used 10w 40 oil,replaced the clutch cable and plates and the bike wont move. i got the bike about a month ago, and it rode perfectly one time. the next time i hopped on her( about 3 hours after she was riding fine) she would barely move. I noticed the clutch was starting to smell burnt, so i took her back to the garage. I did a full clutch change and now when i adjust it at the 3 adjustment points i can either get a fully engaged clutch, or a fully disengaged one. I am pretty sure the plates are i correctly, since i used the partszilla schematics to put everything back. Any ideas?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top