Motorcycle Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
This site requests you introduce yourself as one of your first few posts so people know you are serious and not a hit and run type poster. Introductions found here ... https://www.motorcycleforum.com/forums/new-member-introduction.305/
Well with a lot of help from people who know a lot more than I do about bikes, ‘Project Scrappy Hyosung’ is making good progress.
However we seem to have reached a difficult patch that could stall the project for a long time.

It’s a carbed version of a Hyosung GT125r and the rubber inlet manifolds are fo*ked!
I’ve done all the research on the net? I think I have??, but I just can’t find anything without it costing more than the entire project is worth.

What I’m asking the mighty and wise BCF is : does anyone know of any sites/retailers that might be able to help me please?
Or does anyone have a scrapper living in thier back garden?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top