Motorcycle Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
A bit more information would be helpful, but to start make sure you have a good battery and give your breaker points a cleaning and tune up.
I had my batt charge it reads 5.5 on multi meander , part store said it was bad wouldn't take any more charge. But bike dosnt have cdi and supposed start with or without batt. Can you tell me what the continually is in the coil,one came on bike read 1.5 ohms had one here on scooter had two connection instead one but it reads 4.5 internet said most supposed read between 3 and 4 I got one off friend junk bike one connection like mine it reads 1.5 so I don't know and were would other connection lead wire in at? One goes to coil and points back down to stator.

Sent from my VS425PP using Tapatalk
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top