Motorcycle Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
4,530 Posts
Discussion Starter #1
I put some HID light with a blue halo light on the FZ6...looks great and loving the extra light. One of the bulbs went out and it's a PIA to change now with how BKMOTO has the wiring set up. These pictures of from the install on a Ninja 650, same as install for my bike.
http://www.riderforums.com/ninja-650r-accessories/71591-how-install-bkmoto-bixenon-hid-projectors-angel-eyes-halos-2008-ninja-650r.html

If you go down to where he is showing how to do the wiring...starting about the 22nd picture..from there he goes to pulling all those little wires thru the new seal on the dust cap. Every time I have to replace a bulb...like today...I have to pull those little wires back thru that seal and install them thru the new seal that comes with the new bulb. The little wire connectors he sends with the kit for the white wires and the little black & red wires, they bit the dust and were connected with a different type, posi-lock. But, there has to be an easier way to set this up. Any ideas?
 
1 - 1 of 1 Posts
Top