Motorcycle Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I'm hoping someone out there can help me because I am completely stumped on a problem with a 1974 Honda cb125s. When I pull in on the clutch lever, the lever starts vibrating and you can hear a steady rattle that gets louder the more I pull in on the lever. When the lever is all the way and the clutch should be disengaged, the bike starts to go under s slow load and if left at idle, will stall. So far I pulled the clutch out. Measured the plates, which were fine. Then replaced the clutch springs and bearing, but it is still a mess. Any ideas wold be super appreciated!
 

· Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
Let me try to clarify. When I pull in on the clutch lever, there is a rat-tat-tat coming from the crank case and matching vibration on the clutch lever. When I have it all the way in and shift into 1st, the rear wheel will start to turn (even with the lever still pulled). Then it just slowly stalls.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top