Motorcycle Forum banner

shift

  1. 07 honda cbr1000rr stuck neutral

    Motorcycle Repair
    Hello Im new on this forum but i really need some help. i bought an honda cbr1000rr from 07 it has 32k km on it. The dude before me crashed it hard. I'm almost done fixing the bike. I only have 2 problems left. 1. The bike wont go in gear. When i first got it it could go into every gear...
  2. 1972 Honda Shift Lever Question.

    New Member Introductions
    Hey everyone, After scouring the internet for a few hours, I found this site and made an account. I'm riding a 1972 Honda CB500, and today while riding, the shift lever popped down past it's usual position, and I could no longer shift. When I looked closer, I saw that the teeth on shift...
  3. When to shift (1984 Yamaha XV1000)

    First Bike / New Rider
    Howdy, My first road bike & I'm having a blast. My last dirt bike was 30 years ago when I was a kid...actually it was a road bike I rode around on when we were up camping...it was blue & a 100, that's about all I know. Anyway, I don't have the users manual for this bike & I'm wondering when to...
  4. Gear shift PING?

    General Motorcycle Discussion
    Hey, Thanks everyone for sharing such enthusiasm. About 3 weeks ago I realized I needed an oil change (over-due) on my 2002 Honda Shadow 600CC 4speed. At the same time I noticed when I would hit 4th gear (at 40mph) it would make a "metallic Ping" sound, very abnormal from the "thump" or...
  5. trouble shifting gears

    First Bike / New Rider
    This is the most basic of basic questions that I need help with! I have a Honda CL160, and I can't figure out how to shift. I'm having trouble figuring out where neutral is, (click all the way down?), and why (if I'm even right about this) 1st is a click up, and 2nd is a click down through...
  6. Shift lever is loose

    Motorcycle Repair
    Hey guys, I have a 1981 Honda CM200. I was riding it yesterday and, as I was on a side road, the shift lever went loose on me. Basically, if I kick it down to 1st it doesn't click in gear. However, it will start up with the electric start. From there, it's just loose. If I attempt to kick...
  7. Shift Shaft Seal

    Motorcycle Repair
    I put a new stator in my Sabre (VT1100C2). Everything went well, except nobody tells you that prying the engine cover over the shift shaft seal is a little more than just pulling the cover off. This, I think is the experience part that's not added to the Clymer/Chilton ,which is why these forums...
Top